Ricoh FT4460, Service Manual, Page: 157 / 413

28 February 1989
1.5.6 Key Counter Holder Installation (Option)
1.
2.
3 .
4.
5 .
6 .
7.
8 .
Open the front cover.
Remove the right cover [A] (6 screws).
Remove the key counter cover [B] (2 screws).
Remove the right inner cover [C] and the stopper chain [D] (3 screws).
To do so, lower the Development unit supporter (insert screwdriver in hole
in right inner cover) and release the transfer unit lever [A1]. Hold down
the A2 lever and pull off the cover.
Remove the shorting plug [E] from the 4P key counter connector.
Connect the 4P connector of the key counter holder [F] to the key
counter harness through the key counter access hole.
Position the fixing plate [G] as shown in the illustration and insert the key
counter holder.
Align the holes in the fixing plate with the mounting holes of the key
counter holder and secure the key counter holder (2 screws).
NOTE: The fixing plate has three different hole sizes. Use the holes that
match those on the counter that you are installing.
9. Reinstall all covers.
3-18