Ricoh AP-C3, Field Service Manual, Page: 741 / 1334

1001 Bit Switch
005 Bit Switch 9 0 1
bit 0
PDL Auto Detection timeout of jobs submitted via
USB or Parallel Port (IEEE 1284).
"Disabled
(Immediatel
y)"
"Enabled
(10 seconds)"
To be used if PDL auto-detection fails. A failure of PDL autodetection doesn't
necessarily mean that the job can't be printed. This bit switch tells the device whether
to time-out immediately (default) upon failure or to wait 10 seconds.
bit 1 DFU - -
bit 2 Job Cancel Disabled
(Not
cancelled)
Enabled
(Cancelled)
If this bit switch, all jobs will be cancelled after a jam occurs.
Note: If this bitsw is enabled, printing under the following conditions might result in
problems:
- Job submission via USB or Parallel Port
- Spool printing (WIM >Configuration > Device Settings > System)
bit 3 PCL/PS bypass tray paper rotation (SEF/LEF) 0: Disable 1: Enable
This bitsw causes the device to revert to the behavior of previous generations. It only
takes effect if "Bypass Tray Setting Priority" = "Driver/Command".
Previous spec (bitsw=1): If a standard sized paper mismatch occurred in the bypass
tray, the MFP always prompted for SEF paper.
If this bitsw=0 (default) then in the event of a standard sized paper mismatch, the
MFP will always prompt for paper of the rotation (SEF/LEF) determined by the MFP
bypass tray paper setting or by the bypass tray sensor.
Bit 4
to 7 DFU
- -
1003 [Clear Setting]
1003 1
Initialize Printer System
Initializes settings in the "System" menu of the user mode.
1003 3 Delete Program
Main SP Tables-9
739