Ricoh AP-C3, Field Service Manual, Page: 1170 / 1334

162
Connection Timing Adjustment Incoming
When the Call Center calls out to an embedded RCG-M modem, it sends a repeating ID
tone (*#1#). This SP sets the time the line remains open to send these ID tones after the
number of the embedded RCG-M modem is dialed up and connected.
[0 to 24 / 1 / 1 /step]
The actual amount of time is this setting x 2 sec. For example, if you set "2" the line will
remain open for 4 sec.
163
Access Point
This is the number of the dial-up access point for RCG-M. If no setting is done for this SP
code, then a preset value (determined by the country selected) is used.
Default: 0
Allowed: Up to 16 alphanumeric characters
164
Line Connecting
This SP sets the connection conditions for the customer. This setting dedicates the line to
RCG-M only, or sets the line for sharing between RCG-M and a fax unit.
[0 to 1 / 0 / 1 /step]
0: Sharing Fax
1: No Sharing Fax
• If this setting is changed, the copier must be cycled off and on.
• SP5816 187 determines whether the off-hook button can be used to interrupt a
RCG-M transmission in progress to open the line for fax transaction.
173 Modem Serial No. This SP displays the serial number registered for the RCG-M.
174
Retransmission Limit
Normally, it is best to allow unlimited time for certification and ID2 update requests, and
for the notification that the certification has been completed. However, RCG-M
generates charges based on transmission time for the customer, so a limit is placed upon
the time allowed for these transactions.
If these transactions cannot be completed within the allowed time, do this SP to cancel
the time restriction.
3. SP Mode Tables
246