Ricoh AP-C3, Field Service Manual, Page: 200 / 1334

7. Remove the tape from the drive pulley.
8. Insert a scanner-positioning pin [L] through the 2nd carriage hole [M] and the left holes [N] in the
front rail. Insert another scanner positioning pin [O] through the 1st carriage hole [P] and the right
holes in the front rail [Q].
9. Insert two more scanner positioning pins through the holes in the rear rail.
10. Screw the drive pulley to the shaft [R].
11. Screw the scanner wire bracket to the front rail [S].
12. Install the scanner wire clamp [T].
13. Pull out the positioning pins.
• Make sure the 1st and 2nd carriages move smoothly after you remove the positioning pins.
Do steps 8 through 13 again if they do not.
• After replacing the scanner wire, do the image adjustments in the following section of the
manual ( p.163 in the "Image Adjustment" section).
Rear Scanner Wire
1. Exposure glass ( p.184)
2. Scanner rear frame ( p.189)
3. Scanner motor ( p.189)
4. IOB with bracket ( p.323)
5. Rear rail frame [A] ( x 5)
4. Replacement and Adjustment
198