Ricoh AP-C3, Field Service Manual, Page: 1116 / 1334

007 Without Developer *ENG [0 to 5 / - / 0.1 V/step]
008 With Developer *ENG [0 to 5 / - / 0.1 V/step]
009 Serial Number 1 *ENG
[0 to 255 / - / 1 V/step]
010 Serial Number 2 *ENG
011 Adjustment: Vt *ENG [0 to 5 / - / 0.1 V/step]
012 Adjustment: Vtref *ENG [0 to 5 / - / 0.1 V/step]
013 Adjustment: Vtcnt *ENG [0 to 5 / - / 0.01 V/step]
014 Adjustment: Gamma *ENG [0 to 2.55 / - / 0.01 mg/cm
2
/kV /step]
015 Adjustment: Vcnt Result *ENG [0 to 9 / - / 1 /step]
3800
[Waste Toner Full Detection]
Displays/ adjusts the toner collection bottle detection settings. These SPs are used for
NRS.
001 Condition *CTL [0 to 4 / 0 / 1 /step]
002 Detection Times *CTL [0 to 50 / 0 / 1 /step]
003 Print Page After Near Full *CTL [0 to 1000 / 0 / 1 sheet/step]
004 Pixel Count After Near Full *CTL [0 to 200000 / 0 / 1 cm
2
/step]
005
Pixel Count After
Replacement
*CTL
Displays the pixel counter after replacement
of toner collection bottle.
[0 to 200000 / 0 / 1 cm
2
/step]
008 Coefficient *ENG [0.1 to 1.5 / 1 / 0.1 /step]
011
Notice Setting *ENG
Enables or disables the calling for @Remote.
[0 or 1 / 1 / - ]
0: Enable @Remote calling
1: Disable @Remote calling
NOTE:
If the toner collection bottle has been replaced before the machine detects used toner
near full when this setting is set to "0", the machine cannot detect toner collection bottle
near full. In that case, set SP3-902-017 to "1".
3. SP Mode Tables
192