6100-Gfast Multifunction Network Analyzer Operation Manual
8
© 2020 Radiodetection Ltd
Fig
. 3.5:
6100-Gfast connections
– end view
Fig
. 3.6:
6100-Gfast connection identification
Note: On the 6100-Gfast model, to test an ADSL 1/2/2+
Annex B interface, the unit uses the second pair
(pins 2-5) in the DSL WAN RJ11 connector.
When connecting the unit to a wall socket with a
modem cable that uses the first pair (pins 3-4),
use the red cable (pair 2) of the RJ14 to dual RJ-
11 DSL Bonding Test Cable (part number
10/6100-CABLE-BOND-RJ14-RJ11X2) provided,
and the RJ11 female adapter (part number
10/6100-RJ11-WAN-ADPTR).
WARNING! A 50 to 500 V limited power source
may be present on connector T/R/G (A/B/E),
T1/R1/G (A1/B1/E) when the unit is testing
isolation resistance. Use with caution.
WARNING! These connections are intended for
the express purpose of electrical testing of
common telephone line conductors, within
the ranges specified in the Technical
Specifications found on the Radiodetection
Web site. The device is not intended to be
used on telephone lines having voltages
greater than 280 VAC or 400 VDC, and it is
also not intended to be used on power
distribution circuits.
CAUTION: The unit is protected against damage
caused by fault voltages that may be
present on lines under test. Do not connect
the unit if the maximum expected fault
voltage is greater than 500 volts.
3.2 Technical specifications
Please see the separate Technical Specification
document, available at
Primary Tip/A wire of phone line
Primary Ring/B wire of phone line
Shield of phone line
Secondary Tip/A
wire of phone line
Secondary Ring/B
wire of phone line
Ground
terminal
Primary Tip/A and
Ring/B connectors
for DSL and
copper testing
Ethernet/1GigE LAN port
Secondary Tip/A and
Ring/B connectors
for DSL and 4-wire
copper testing
Ethernet/
1GigE
WAN port
DSL port
