6100-Gfast Multifunction Copper Tester Operation Manual
© 2020 Radiodetection Ltd
165
IPTV Test Setup
IPTV test supports STB (set-top box) emulation mode
over xDSL and Ethernet interfaces enabling the
6100-Gfast to join and leave multicast IPTV streams.
The following parameters can be configured from the
Test Setup
tab:
Display Mode
is either the
Channel Name
or
#
used for displaying channel information in the
result pages.
IGMP Version
is a value of either
2
or
3
used
to send IGMP join/leave messages.
Note: If you change the
IGMP Version
from the default
of
2
to
3
, you must reboot your unit.
Max TS Packet Loss Ratio
is an editable
percentage, ranging from 1 to 50, used to
qualify if the IPTV stream is stable.
Max ZAP Time
is an editable value ranging
from 0 to 10,000 that measures the channel
switch time in ms.
Channel List Setup
button accesses the page
to configure parameters for channel analysis.
Auto IPTV Test Setup
button (only available In
Auto Test Setup) accesses the setup page to
automatically run an IPTV test.
Clone Data WAN
(only available in
Manual
Test Setup
) allows you to add the WAN
configuration from the
Connection Setup
tab
to this test, by selecting
Yes
. If you select
No
,
all the parameters from the
Connection Setup
page, beginning with
Access Mode
, are listed
and can be modified.
One additional
Access Mode
,
Bridged
(DHCP)
can be configured here in the IPTV
WAN setup, to support the modem in bridge
mode and WinCE in DHCP. This allows WinCE
to get the WAN IP address via DSL connection
through the modem's bridge.
Bridged (DHCP)
uses same parameters as
DHCP
mode.
To configure test setup values:
1. Press the up/down arrow keys to select the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press
to confirm the value.
5. If you make any changes to the parameter
values, you will be prompted to save changes
done in Profile. Press the on-screen function
keys to save or cancel your input.
