6100-Gfast Multifunction Copper Tester Operation Manual
© 2020 Radiodetection Ltd
41
Standard
The
Standard
tab allows you to set unit parameter
values composed of the following:
Standard Selection
Standard
allows you to specify if the copper
tests should conform to the
ITU
(International
Telecommunications) or
ANSI
(American
National Standards Institute) standard.
Note: Selecting the
Standard
resets the default
Measurement Units
,
Label Customization
, and
Test Parameters Preset
for the page.
Measurement Units
o
Distance
lists the measurement units
for distance in feet or meters.
o
Temperature
lists the measurement
units for temperature in
⁰
F
(Fahrenheit)
or
⁰
C
(Celsius).
o
Level
lists the units of power level in
dBm or dBRN.
o
Capacitance
lists the units of
capacitance for Tip and Ring in
nF/km
or
nF/mi
.
o
Resistance
lists the units for
resistance in
Ω/km
or
Ω/mi
.
o
Attenuation
lists the units for the
reduction in signal strength or insertion
loss of the cable, in
dB/km
or
dB/mi
.
o
Power Spectral Density
(PSD) lists
the units to measure the noise energy
at a point in a noise spectrum. Units
are dependent on the previously
selected
Level
.
o
Cable Gauge Unit
allows you to select
either
AWG
or
mm
wire gauge. AWG
is the default for ANSI and mm for ITU.
If you select AWG, only AWG cables
will be displayed in the
Cable
Book
\
Select Cable
list and test pages.
o
NTD
(Network Terminal Device)
Provider
allows you to filter out certain
devices in the
Pair Detective
test
dependent on your provider.
None
(default) filters out all devices except
Short, Phone, and Phone Off Hook.
Disabled
does not run the
Device
Detection
as part of
Pair Detective
test.
o
VOP
allows you to select the velocity of
propagation for the cable as a Ratio,
Percentage, or
V/2 m/μs (meters per
microsecond).
Label Customization
Connection
lists the type of cable connection:
T-R-G
or
A-B-E
.
Test Parameters Preset
o
Power Line Frequency
lists the
frequency value of the power line.
o
Noise Filter
lists the type of noise
filters to use.
To select the parameter values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options.
4. Press
to confirm the value.
