SNC 450x User’s Guide
89
Ready.
set ipaddress DP0 172.16.5.198
Ready.*
set IPDHCP [port number] [status]
When enabled,
set IPDHCP
allows the SNC to acquire its IP address from a network DHCP (Dynamic Host
Configuration Protocol) server. The network must have at least one DHCP server. When disabled, the SNC
uses the default IP address unless changed through the CLI. A
saveConfiguration restart
command must
be used to permanently save this configuration. Refer to
get IPAddress [port number]
on page 67
and
get
IPDHCP [port number]
on page 68. DHCP is disabled by default. This command must be followed by
saveConfiguration restart
.
Ready.
set ipdhcp all enabled.
Ready.*
set IPGateway [port number] [IP address]
The
set IPGateway
command controls the current gateway for the SNC Ethernet ports where
xxx.xxx.xxx.xxx
is the IP gateway address and if IPDHCP has not been enabled. The default setting is
“0.0.0.0." Refer to
get IPGateway [port number]
on page 68. This command must be followed by
saveConfiguration restart
.
Ready.
set ipgateway all 0.0.0.0
Ready.*
mp0
Ethernet management port labeled Ethernet port 2
10.0.0.3
Port Number
Meaning
mp0
Ethernet management port labeled Ethernet port 2
dp0 or dp1
Ethernet data port labeled Ethernet port 0 or Ethernet port 1
all
All Ethernet port connections
Status
Meaning
enabled
Port acquires IP address from network DHCP server
disabled
Port uses default IP address unless changed through CLI
Port Number
Meaning
mp0
Ethernet management port labeled Ethernet port 2
dp0 or dp1
Ethernet data port labeled Ethernet port 0 or Ethernet port 1
all
All Ethernet port connections
Port Number
Meaning
Default value
Summary of Contents for SNC 4500
