SNC 450x User’s Guide
85
Ready.
set displayeventlogfilter scsi warn enabled
Ready.
set DisplayTraceLogFilter [SCSI | all] [port number] [status]
The
set DisplayTraceLogFilter
command controls the display of data for specific SNC ports when the
command DisplayTraceLog is enabled. If enabled for a particular SNC port, that port is masked when the
command DisplayTraceLog is issued. The default setting is “disabled” for all ports. Refer to
get
DisplayTraceLogFilter [SCSI | all] [port number]
on page 65. This command takes effect immediately.
Ready.
set displaytracelogfilter scsi 0 enabled
Ready.
Log Level Choices
INFO
WARN
CRIT
FAIL
ALL
Where:
INFO =
Information
WARN =
Warnings
CRIT =
Critical events
FAIL =
Failures
ALL =
All of the above
Status
Meaning
enabled
The subsystem and log level chosen are masked when in
DisplayEventLog
mode
disabled
The subsystem and log level chosen are shown when in
DisplayEventLog
mode
CAUTION
Contact ATAC before using this command.
Port Number
Meaning
0 or 1
SCSI connection labeled SCSI port 0 or SCSI port 1
all
All SCSI port connections
Status
Meaning
enabled
The chosen port is masked when in
DisplayEventLog
mode
disabled
The chosen port is shown when in
DisplayEventLog
mode
Summary of Contents for SNC 4500
