![background image](http://html2.mh-extra.com/html/quantum/snc-4500/snc-4500_user-manual_4004287104.webp)
98
Management Port Command Reference
The following example determines the current NTP server, then changes it to a different server. The first
server is no longer listed.
Ready.
get sntpserver
5
;SNTP Server IP Addresses
;========================
192.43.244.18
129.6.15.28
AUX
132.163.4.101
AUX
Ready.
set sntpserver 132.163.4.101
Ready.*
get sntpserver
5
;SNTP Server IP Addresses
;========================
132.163.4.101
129.6.15.28
AUX
132.163.4.101
AUX
Ready. *
set SpeedWrite SCSI [sb st sl | all] [status]
The
set SpeedWrite
command improves the performance of WRITE commands to SCSI devices attached
to the SNC. Enabling the SpeedWrite command for a specific SCSI bus (
sb
), target (
st
), and LUN (
sl
) of a
mapped SCSI device enables the SpeedWrite state for the device at that address. Enabling
all
sets the
SpeedWrite state for each currently mapped SCSI device on the SNC. Disabling the
set SpeedWrite
command leaves the SNC at current WRITE performance levels. A
saveConfiguration restart
command
must be used to permanently save this configuration.
The single-stream WRITE performance with SpeedWrite enabled is between 60 and 100% greater than
when SpeedWrite is disabled.The SpeedWrite capability has no effect on READ commands. Refer to
get
SpeedWrite SCSI [bus target LUN]
on page 75.
129.6.15.28
time server at
www.time-a.nist.gov
132.163.4.101
time server at
www.time-a-timefreq.bidrdoc.gov
CAUTION
Contact ATAC before using this command.
Parameter
Meaning
sb
SCSI bus
st
SCSI target
sl
SCSI LUN
all
all currently-mapped devices
Possible IP Addresses
Meaning
Summary of Contents for SNC 4500
