![background image](http://html2.mh-extra.com/html/quantum/snc-4500/snc-4500_user-manual_4004287098.webp)
92
Management Port Command Reference
set iSNSLoginControl [status]
The
set iSNSLoginControl
command specifies whether or not the SNC delegates its access control and
authorization to an iSNS server. The default setting is “disabled.” Refer to
set iSNSServer [IP address]
on
page 92
and
get iSNSLoginControl
on page 70.
Ready.
set isnslogincontrol disabled
Ready.*
set iSNSServer [IP address]
The
set iSNSServer
specifies the IP address of a valid iSNS server from which the SNC attempts iSCSI
initiator discovery where xxx.xxx.xxx.xxx is the IP address. Setting to 0.0.0.0 disables iSNS server lookup.
The default setting is “0.0.0.0." A
saveConfiguration restart
command must be used to permanently save
this configuration. Refer to
get iSNSServer
on page 71. This command must be followed by
saveConfiguration restart
.
Ready.
set isnsserver 192.16.5.198
Ready.*
set MaxOpTemp [temperature]
The
set MaxOpTemp
command sets the maximum internal operating temperature of the SNC in degrees
Celsius. If the internal temperature of the SNC rises above the maximum operating temperature, thermal
control event handling occurs. Valid values are from 55 to 70
.
The default setting is “70." Refer to
get
MaxOpTemp
on page 71. This command must be followed by
saveConfiguration restart
.
Ready.
set maxoptemp 60
Ready.*
CAUTION
Contact ATAC before using this command.
Status
Meaning
enabled
The SNC delegates its access control and authorization to an iSNS server
disabled
The SNC retains its access control and authorization
CAUTION
Contact ATAC before using this command.
CAUTION
Contact ATAC before using this command.
Valid Temperature Values
55-70
Summary of Contents for SNC 4500
