![background image](http://html2.mh-extra.com/html/quantum/snc-4500/snc-4500_user-manual_4004287028.webp)
22
Getting Started
Figure 1
on page 4 and
Figure 2
on page 4 show the connectors on the SNC.
2
Work from the computer attached to the SNC serial port. After the SNC
Ready
prompt is returned,
change the IP address of the management port by issuing the
set IPAddress mp0
command. The
default IP address for the management port is “
10.0.0.3.
” The example below uses a hypothetical IP
address from the user’s internal network.
Ready.
set IPAddress mp0 172.17.76.3
Press
Enter
.
Ready.*
3
After the SNC
Ready
prompt is returned, issue the
set IPSubnetMask mp0
command. The default
subnet mask is “
255.255.0.0
.”
Ready.
set IPSubnetMask mp0 255.255.255.0
Press
Enter
.
Ready.*
4
After the SNC
Ready
prompt is returned, issue the
set IPGateway mp0
command. There is no default
gateway.
Ready.
set IPGateway mp0 172.17.76.0
Press
Enter
.
Ready.*
CAUTION
• Obtain appropriate IP addresses, gateways and subnet masks from
your network administrator.
• The recommended configuration is one where DHCP has been
disabled.
• You must substitute a valid IP address for the IP address used in the
example.
• Some completed configuration commands do not take effect until
you have issued the saveConfiguration command. When this is the
case, the Ready prompt will be followed by an asterisk. You can
issue the saveConfiguration command after each such
configuration command or wait until the end of the configuration
session before saving.
CAUTION
You must substitute a valid subnet mask for the subnet mask used in
the example.
CAUTION
You must substitute a valid gateway for the gateway used in the
example.
Summary of Contents for SNC 4500
