Quantum SNC 4500, User Manual

Page: 100 / 122

94 Management Port Command Reference
Because the
Ready
prompt is followed by an asterisk, you must issue the saveConfiguration <status>
command to complete the change.
set SCSIInitID [port number] [ID choices]
The set SCSIInitID command specifies the SCSI initiator ID to be used on the specified SCSI port. All maps
coinciding with the user-specified SCSIInitID must be set to offline and becomes invalid upon issuing this
command. Choices are 0 to 15. The default setting is “7." Refer to
get ScsiInitID [port number] [ID choices]
on page 72. This command must be followed by saveConfiguration restart .
The following example specifies the SCSI initiator ID on SCSI port 0 as 15.
Ready.
get SCSIInitID 0 1
ScsiInitID = 7
Ready.*
set SCSIInitID 0 15
Ready.*
set SCSIPortBusSpeed [port number] [speed]
The set SCSIPortBusSpeed command controls the transfer rate at which the SNC negotiates with its SCSI
devices. Choices are fast, ultra, ultra2 and ultra3. The default setting is “ultra3." Refer to get
SCSIPortBusSpeed [port number] on page 72. This command must be followed by saveConfiguration
restart .
Ready.
set scsiportbusspeed 0 ultra2
Ready.*
CAUTION
Contact ATAC before using this command.
Port Number Meaning
0 or 1 SCSI connection labeled SCSI port 0 or SCSI port 1
SCSI Initiator ID Choices
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
CAUTION
Contact ATAC before using this command.
Port Number Meaning
0 or 1 SCSI connection labeled SCSI port 0 or SCSI port 1
Speed Choices
fast ultra ultra2 ultra3