![background image](http://html2.mh-extra.com/html/quantum/snc-4500/snc-4500_user-manual_4004287087.webp)
SNC 450x User’s Guide
81
The following example shows the response to
restoreConfiguration default:
Ready.
restoreconfiguration default
Ready.
route iSCSI [lun] [SCSI | delete] <SCSI btl>
The
Route iSCSI
command assigns an iSCSI LUN protocol address to a target destination device. More
than one iSCSI LUN can be assigned to a SCSI BTL (bus, target, LUN). If you try to map a new SCSI BTL
to the same iSCSI LUN, the new BTL overwrites the previous map. This command takes effect immediately.
The following verbose output shows the results of a
RouteDisplay iSCSI
command, followed by a
Route
iSCSI
command setting the SCSI LUN 9 to the SCSI bus 0, target 9 and LUN 0, followed by another
RouteDisplay iSCSI
command to show the change in mapping:
routedisplay iscsi
11
;Lun SB ST SL
;===================
0 Bridge
1 0 0 0
2 0 1 0
3 0 2 0
4 0 3 0
5 1 0 0
6 1 1 0
7 1 2 0
8 1 3 0
Ready.
route iscsi 9 scsi 0 9 0
Ready.
routedisplay iscsi
12
;Lun SB ST SL
;===================
Status
Meaning
Default
Factory-set default configuration
Saved
Last saved configuration
SCSI btl
Meaning
b
bus
t
target
l
LUN
Note
Devices mapped by the SNC will be visible across both data ports.
Summary of Contents for SNC 4500
