Quantum SNC 4500, User Manual

Page: 102 / 122

96 Management Port Command Reference
The
set
SCSIPortTermination configures the SCSI internal termination of the SCSI port. A
saveConfiguration restart command must be used to permanently save this configuration. The default
setting is “enabled." Refer to get SCSIPortTermination [port number] on page 73.
Ready.
set scsiporttermination 0 disabled
Ready.*
set SCSIPortWideTransfer [port number] [status]
The set SCSIPortWideTransfer command specifies whether or not wide SCSI transfers are negotiated. A
saveConfiguration restart command must be used to permanently save this configuration. The default
setting is “enabled." Refer to get SCSIPortWideTransfer [port number] on page 74.
Ready.
set scsiportwidetransfer disabled
Ready.*
set SerialPortBaudRate [rate]
The set SerialPortBaudRate command configures the baud rate for the RS-232 serial port. The number of
data bits per character is fixed at 8 with no parity. Choices are 2400, 9600, 19200, 38400, 57600, 115200.
The default setting is “115200." Refer to
get SerialPortBaudRate on page 74. This command must be
followed by saveConfiguration restart .
Port Number Meaning
0 or 1 SCSI connection labeled SCSI port 0 or SCSI port 1
Status Meaning
enabled The SCSI port is configured for internal termination
disabled The SCSI port is not configured for internal termination
CAUTION
Contact ATAC before using this command.
Port Number Meaning
0 or 1 SCSI connection labeled SCSI port 0 or SCSI port 1
Status Meaning
enabled Wide SCSI transfers are negotiated
disabled Wide SCSI transfers are not negotiated
Rate Choices
2400 9600 19200 38400 57600 115200