Quantum SNC 4500, User Manual

Page: 101 / 122

SNC 450x User’s Guide 95
set SCSIPortResetOnStartup [port number] [status]
The set SCSIPortResetOnStartup command specifies if the SCSI port is reset after turning the unit on or
restarting the firmware. The default setting is “enabled.” Refer to get SCSIPortResetOnStartup [port
number] on page 73. This command must be followed by saveConfiguration restart .
Ready.
set scsiportresetonstartup 0 disabled.
Ready.*
set SCSIPortSyncTransfer [port number] [status]
The set SCSIPortSyncTransfer command specifies whether or not synchronous SCSI transfers are
negotiated with devices on the specified SCSI port. A saveConfiguration restart command must be used
to permanently save this configuration. The default setting is “enabled." Refer to get SCSIPortSyncTransfer
[port number] on page 73.
.
Ready.
set scsiportsynctransfer 0 disabled
Ready.*
set SCSIPortTermination [port number] [status]
CAUTION
Contact ATAC before using this command.
Port Number Meaning
0 or 1 SCSI connection labeled SCSI port 0 or SCSI port 1
Status Meaning
enabled Resets the SCSI port after turning power on
disabled Does not reset the SCSI port after turning power on
CAUTION
Contact ATAC before using this command.
Port Number Meaning
0 or 1 SCSI connection labeled SCSI port 0 or SCSI port 1
Status Meaning
enabled Synchronous SCSI transfers are negotiated
disabled Synchronous SCSI transfers are not negotiated
CAUTION
Contact ATAC before using this command.