62
Management Port Command Reference
00 00 00 00 00 00
Stat= 00
Sense Data = 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00
Ready.
exit
The
exit
command ends the current TCP/IP CLI session. It has no effect if used during a serial CLI session.
A Telnet session ends after 15 minutes of inactivity. No more than three Telnet sessions can be active at
one time. This command takes effect immediately.
firmwareRestart
The
firmwareRestart
command causes the SNC to reboot and then re-initialize its firmware. When the
firmware has finished rebooting, the
Ready
prompt is displayed. This command takes effect immediately.
Uart is Initialized
DRAM Data Line Test Passed
SRAM Data Line Test Passed
BBRAM Data Line Test Passed
DRAM Address Line Test Passed
SRAM Address Line Test Passed
BBRAM Address Line Test Passed
DRAM Pattern Test 1 Passed
DRAM Pattern Test 2 Passed
DRAM Pattern Test 3 Passed
DRAM Pattern Test 4 Passed
SRAM Pattern Test 1 Passed
SRAM Pattern Test 2 Passed
SRAM Pattern Test 3 Passed
SRAM Pattern Test 4 Passed
BBRAM Pattern Test 1 Passed
BBRAM Pattern Test 2 Passed
BBRAM Pattern Test 3 Passed
BBRAM Pattern Test 4 Passed
DRAM Swap Pattern Test1 Passed
DRAM Swap Pattern Test2 Passed
DRAM Swap Pattern Test3 Passed
DRAM Swap Pattern Test4 Passed
***** Memory Tests Complete *****
Memory Clear Finished
EPLD Version 0 Detected
DS1629_DVC_TYPE initialized
ADIC SNC 450x
(c) 2003 ATTO Technology, Incorporated.
Summary of Contents for SNC 4500
