Quantum SNC 4500, User Manual

Page: 59 / 122

SNC 450x User’s Guide 53
get Date display the current date 63
get MaxOpTemp display the maximum internal operating temperature 71
get MinOpTemp display the minimum internal operating temperature 71
get OpTempWarn display the number of degrees before a thermal control event
warning is output 71
get SNTP display whether or not NTP (Time Network Protocol) has
been enabled 74
get SNTPServer display the NTP server address 74
get Time display the current time 76
get TimeZone display the current time zone 76
get Username display the current username 77
reserve prevent other users from accessing the SNC 80
SCSIPortReset reset the specified SCSI bus 83
set BridgeName create a name for a particular SNC 83
set Date set the current date 84
set MaxOpTemp set the maximum operating temperature 92
set MinOpTemp set the minimum operating temperature 93
set OpTempWarn set the number of degrees before a thermal control event
warns about the temperature change through system log
entries 93
set Password set a password for Telnet, SNC Manager and ftp sessions 93
set SNTP determine whether or not the SNC tries to contact a specified
Network Time Protocol (NTP) server 74
set SNTPServer set the Network Time Protocol (NTP) server address 97
set Time set the time 99
set TimeZone set the time zone 100
set Username set a username for Telnet, SNC Manager and ftp sessions 101
ZModem allow transfer of a firmware image to or from the SNC using
the ZModem file transfer protocol through the RS-232
interface 102
Diagnostic Commands
clearEvent Log clear the contents of the event log 57
clearTraceLog clear the contents of the trace log 58
displayEventLog display the contents of the event log 58
Table 6 Alphabetical Listing of Commands by Functional Group
Command Meaning Page