Quantum SNC 4500, User Manual

Page: 105 / 122

SNC 450x User’s Guide 99
Ready.
set speedwrite scsi all enabled
Ready.
set SpeedWriteDefault [status]
When the set SpeedWriteDefault command is enabled, any newly-mapped SCSI device are set at the
SpeedWrite performance level. When set SpeedWriteDefault is disabled, the SNC does not attempt
SpeedWrite performance enhancement to newly-mapped SCSI devices. The default setting is “disabled."
A
saveConfiguration restart command must be used to permanently save this configuration. Refer to get
SpeedWriteDefault on page 75.
Ready.
set speedwritedefault enabled
Ready.*
set Time [time]
The set Time [hh:mm:ss] command sets the time for the SNC if NTP has been disabled. Refer to set
SNTPServer [IP address] on page 97. This command takes effect immediately.
The following is an example of how to set the time manually. NTP must be disabled.
Ready.
get time
Time = 14:47:17
Ready.
set time 12:47:17
Time Can Not be set while SNTP is enabled
ERROR Command Not Processed
Ready.
set sntp disabled
Status Meaning
enabled Provides enhanced performance of WRITE commands
disabled Retains the current level of performance of WRITE commands
CAUTION
Contact ATAC before using this command.
Status Meaning
enabled Provides enhanced performance of WRITE commands
disabled Retains the current level of performance of WRITE commands
Time Meaning
hh Two-digit designation of desired hour
mm Two-digit designation of desired minute
ss Two-digit designation of desired seconds