Quantum SNC 4500, User Manual

Page: 108 / 122

102 Management Port Command Reference
When the set WrapEventLog command is enabled, the SNC logs up to 2,048 event entries before
wrapping (overwriting the first entries). If the set WrapEventLog command is disabled, the SNC stops
logging event entries when the buffer is full. The default setting is “enabled." Refer to get WrapEventLog on
page 78. This command must be followed by saveConfiguration norestart .
Ready.
set wrapeventlog enabled
Ready.*
set WrapTraceLog [status]
When the set WrapTraceLog command is enabled, the SNC logs up to 2,048 trace entries before wrapping
(overwriting the first entries). If the set WrapTraceLog command is disabled, the SNC stops logging trace
entries when the buffer is full. The default setting is ”enabled." Refer to get WrapTraceLog on page 78. This
command must be followed by saveConfiguration norestart .
Ready.
set wraptracelog disabled
Ready.*
ZModem [status]
The ZModem Send command allows transfer of a firmware image to or from the SNC using the ZModem
file transfer protocol through the RS-232 interface. Before using this command, ensure that all I/O through
the SNC has stopped. If ZModem fails, you receive an error message with status of the failure. This
command takes effect immediately. Refer to
Updating Firmware Using ZModem on page 34.
The following is an example of the verbose output of a ZModem Send command:
Ready.
zmodem send c:\SNC_firmware\I2500110.ima
Ready.
Status Meaning
enabled Provides labels of parameters
disabled Removes labels of parameters (only output data is shown)
CAUTION
Contact ATAC before using this command.
Status Meaning
enabled Provides labels of parameters
disabled Removes labels of parameters (only output data is shown)
Status Meaning
send Sends information using the ZModem file transfer protocol
receive Ready to receive information using the ZModem file transfer protocol