Quantum SNC 4500, User Manual

Page: 45 / 122

SNC 450x User’s Guide 39
Configuring Advanced Properties
The Advanced CLI configuration page allows you to input any CLI command available through the SNC.
Refer to Management Port Command Reference on page 51.
1 In the text box, type the CLI command.
2 Click the Submit button.
This is equivalent to typing in the CLI command into a TCP/IP or serial port CLI session.
3 A text field beneath the box lists the most recent commands issued to the SNC through this page. If you
enter an incorrect parameter, the CLI help text is displayed, showing the parameters available.
4 If your entry was correct, type at the prompt
saveConfiguration
5 Click the Submit button. Your changes are implemented.
6 To make the changes permanent, restart the SNC (refer to Restarting the Firmware ).
Restarting the Firmware
The Restart Firmware page implements a firmware restart of the SNC and makes permanent any changes
you have made since the last firmware restart. Restarting the firmware can take a few minutes. Refer to
firmwareRestart on page 62.
1 Click the Restart button.
A box tells you to wait until the counter gets to 0, then the browser refreshes.
2 If the browser does not refresh after the counter gets to 0, click the link to refresh it manually.
Getting Help
The Help page gives help information about the CLI commands and troubleshooting tips with links to pages
with help text for each category of options and one link to the Troubleshooting Tips and FAQs page on
the website.
Contact information for technical support is on the right. Help is always available by clicking any word shown
in red on the screen. You can also learn about help by referring to the
help [command name] on page 78.
Note
CLI commands are case insensitive. You can type all upper or all lower
case or a mixture. Upper and lower case in this guide and the
Help screen
are for clarification only.