![background image](http://html2.mh-extra.com/html/quantum/snc-4500/snc-4500_user-manual_4004287073.webp)
SNC 450x User’s Guide
67
get EventLog Filter [subsystem]
The
get EventLogFilter
command displays the data for specific SNC subsystems. Refer to
set
EventLogFilter [subsystem] [event level] [status]
on page 87.
get IdentifyBridge
The
get IdentifyBridge
command displays whether or not
set IdentifyBridge
is enabled. Refer to
set
IdentifyBridge [status]
on page 88.
Ready.
get IdentifyBridge
IdentifyBridge = disabled
Ready.
get IPAddress [port number]
The
get IPAddress
command reports the current IP address, whether it is the default setting, or whether it
was assigned manually or by DHCP. Refer to
get IPDHCP [port number]
on page 68 and
set IPAddress
[port number] [IP address]
on page 88.
The following is an example of the verbose output for a
get ipaddress all
command:
Ready.
get ipaddress all
5
CAUTION
Contact ATAC before using this command.
Subsystem Choices
GEN
ENET
ISCSI
NVRAM
PERF
ECC
ALL
Where:
GEN =
General
ENET =
Ethernet
ISCSI =
SCSI protocol of TCP/IP
NVRAM =
Non-Volatile Random Access Memory
PERF =
Performance
ECC =
Error Correcting/Correction Code
ALL =
All of the above
Port Number
Meaning
mp0
Ethernet management port labeled Ethernet port 2
dp0 or dp1
Ethernet data port labeled Ethernet port 0 or Ethernet port 1
all
All Ethernet port connections
Summary of Contents for SNC 4500
