SNC 450x User’s Guide
87
Ready.
set ethernetspeed dp0 auto
Ready. *
set EventLog [status]
The
set EventLog
command, when enabled, records various system events to the event log. The default
setting is “enabled." Refer to
get EventLog
on page 66. This command must be followed by
saveConfiguration norestart
.
Ready.
set eventlog disabled
Ready.*
set EventLogFilter [subsystem] [event level] [status]
The
set EventLogFilter
command filters the data for specific SNC subsystems. If enabled for a particular
subsystem and level, that subsystem and level is masked while events are being logged. The default setting
is “disabled” for all subsystems and levels. Refer to
get EventLog Filter [subsystem]
on page 67. This
command must be followed by
saveConfiguration restart
.
Ethernet Speed Choices
10
100
1000
auto
CAUTION
Contact ATAC before using this command.
Status
Meaning
enabled
The Event Log records events
disabled
The Event Log is not created
CAUTION
Contact ATAC before using this command.
Subsystem Choices
GEN
ENET
ISCSI
NVRAM
PERF
ECC
ALL
Where:
GEN =
General
ENET =
Ethernet
ISCSI =
SCSI protocol of TCP/IP
NVRAM =
Non-Volatile Random Access Memory
PERF =
Performance
Summary of Contents for SNC 4500
