![background image](http://html1.mh-extra.com/html/quantum/snc-4000/snc-4000_user-manual_4004472077.webp)
SNC 4000 User’s Guide
71
Each command outputs a status “value” in decimal and hexadecimal after execution and before a new
prompt is displayed.
value = 0 = 0x0
Usually a value of 0 indicates success, but some successful commands return a different value.
ampFeatureEnable
The
ampFeatureEnable
command enables the optional multi-path mapping feature. You enable the
feature by entering the unique license key.
SNC > ampFeatureEnable "N499F-ZZ"
Copy OK: 60 bytes copied
AMP Enabled, License is Valid
value = 0 = 0x0
SNC >
If the license key was factory-installed, you can enter the word “enable” (in quotes) rather than the actual
license key.
SNC > ampFeatureEnable "enable"
AMP Enabled, License is Valid
value = 0 = 0x0
SNC >
If
value = 1 = 0x1
message is displayed, it means the license is already installed and multi-path
mapping is already enabled.
If the
value = -1 = 0xffffffff message
is displayed, it means the license is not already installed
and you do need to enter the license key.
arptabShow
The
arptabShow
command displays the contents of the ARP table. The ARP table contains the current
Internet-to-Ethernet address mappings. This information may be useful to the LAN administrator.
SNC4000 > arptabShow
LINK LEVEL ARP TABLE
destination gateway flags Refcnt Use Interface
Virtual Private Map
copyScsiAssign
Copy SCSI assignments from a source channel to a
destination channel
deleteScsiAssign
Delete an assignment previously created
setScsiAssign
Assign a target device to a SCSI channel
showScsiAssign
List the current assigned addresses for the indicated
channel
vpmFeatureEnable
Enable the optional Virtual Private Map feature
vpmFeatureEnabled
Display status information about Virtual Private Map
Table 7
Commands Listed Alphabetically by Function
Command or Command
Group
Description
Page
Summary of Contents for SNC 4000
