![background image](http://html1.mh-extra.com/html/quantum/snc-4000/snc-4000_user-manual_4004472131.webp)
SNC 4000 User’s Guide
125
vpmFeatureEnabled
The
vpmFeatureEnabled
command allows you to check the status of the VPM feature. A returned value
of "1" means that VPM is already enabled. A returned value of "0" means that VPM is disabled. In the
following example, VPM is already enabled.
SNC > vpmFeatureEnabled
vpmFeatureEnabled = 0xc0199468: value = 1 = 0x1
SNC >
vps. See vpsShow
vpsAccessApply
The
vpsAccessApply
command causes the settings that have been changed and stored in memory to
take effect immediately and also saves them to the VPS or eVPS database.
SNC > vpsAccessApply
value = 0 = 0x0
SNC >
vpsAccessClear [disable code]
The
vpsAccessClear
command disables all VPS or eVPS host access to all LUNs except to LUN 0 (the
command and control interface). The disable code is stored as the "MagicNumber" in the output of the
vpsFileShow
command.
The following command example shows how to disable all access using the disable code
oxfacade03
.
SNC >vpsAccessClear 0xfacade03
value = 0 = 0x0
SNC >
vpsAccessSet [hostIndex],[Starting lun],[Ending lun],[Access]
The
vpsAccessSet
command sets the access for the specified range of LUNs for the specified VPS or
eVPS host connection index.
When you enter this command, the settings are stored in memory but are not applied until you enter the
vpsAccessApply
command. The following example shows how to enable the host at connection index 1
to access LUNs 2 through 32. Existing hostIndex values can be determined by looking at the "ID" column
in the output of the
vpsShow [hostIndex]
command.
SNC > vpsAccessSet 1,2,32,1
value = 0 = 0x0
SNC >
Note
When you are using Firmware 4.40 on a Fibre Channel blade, this command is
unavailable.
Access
Meaning
0
Disables access to the LUNs
1
Enables access to the LUNs
Summary of Contents for SNC 4000
