88
Service Port Command Reference
SNC4000 > hlthChkNow
Health Check: Starting level 4 check
Health Check: Step 1 -- Checking System
Health Check: Step 2 -- Checking Interfaces
Health Check: Step 3 -- Checking Devices
Health Check: Step 4 -- Checking Device States
Health Check: Passed
value = 0 = 0x0
host “add”,“hostname”,“ipAddress”
The
host
“
add
” command adds the named host to the host table and host file. If the IP address is already
assigned to a host, then the new name is added as an alias for the host. The
host
“
add
”
command is
invoked to add known hosts and their IP addresses. Alias names are supported, allowing multiple names to
a single host.
The
host
utilities maintain a host file,
nvfs:/mgnt/hosts
, which is used at system startup to initialize the
network hosts table. This table associates network names with IP addresses. Use of the
hosts
table is
entirely optional, but might facilitate frequently needed connections. Each host entry is a single line of the
format:
IP-address
official_host_name
nicknames ...
where
IP-address
is a text string in standard IP Address format (i.e., 10.0.0.2).
official_host_name
is the first name selected for this host.
nicknames
is an optional list of additional aliases for the host (separated by spaces).
The following is an example of host file contents.
192.168.1.90 bruno
200.0.0.42 socrates
200.0.0.45 plato
200.0.0.47 fred
SNC4000 > host "add","plato","200.0.0.45"
host
“
delete
”,“
hostname
”
The
host
“
delete
”
command deletes the named host from the hosts table and hosts file. If the
hostname
is an alias, then only the alias is removed. If
hostname
is the official host name, the entry and
all aliases are removed.
The
host
utilities maintain a host file,
nvfs:/mgnt/hosts
, which is used at system startup to initialize the
network hosts table. This table associates network names with IP addresses. Use of the
hosts
table is
entirely optional, but might facilitate frequently needed connections. Each host entry is a single line of the
format:
IP-address
official_host_name
nicknames ...
where
IP-address
is a text string in standard IP Address format (i.e., 10.0.0.2).
official_host_name
is the first name selected for this host.
Note
The host file does not exist until you enter the
host
“
add
” command.
Summary of Contents for SNC 4000
