![background image](http://html1.mh-extra.com/html/quantum/snc-4000/snc-4000_user-manual_4004472114.webp)
108
Service Port Command Reference
setNettime [value]
The
setNettime
command enables or disables timeserver functionality.
SNC4000 > setNettime 1
Nettime 1 value = 0 = 0x0
setScsiAssign [devID], [channel], [id], [lun]
The
setScsiAssign
command assigns a target device to a SCSI channel [channel] with SCSI Target ID
[id] and Logical Unit Number of [lun].
The indicated channel must be configured to be running in target mode. The [id] and [lun] must be available
on that channel.
The example below shows the device with devID of 64 assigned to ID 0, LUN 0 on SCSI Channel 2.
SNC4000 > setScsiAssign 64,2,0,0
Parameter
Value
Port
0
Changes will apply to all FC
Connections
1
Changes will apply to the FC
Connection (Connection 1)
OS
“
nt
”
“
aix
”
“
solaris
”
“
hp-ux
”
“
linux
”
“
netware
”
“
gateway
”
“
generic
”
“
unisys
”
“
adic snc
”
“
pv-132t-fc
”
“
autosense/nt
”
CAUTION
You must reboot the SNC 4000 after executing this command for the
new setting to take effect.
Value Meaning
0
Disables timeserver functionality
1
Enables timeserver functionality
Note
When you are using Firmware 4.40 on a Fibre Channel blade, this command is
unavailable.
Note
The
targets
command displays the devID as the Idx.
Summary of Contents for SNC 4000
