SNC 4000 User’s Guide
31
In the example shown, the host name of the SNC was “SNC4000” and is now being set to “foster.” The
shell prompt will change to reflect the new name.
SNC4000 > hostNameSet "foster"
Target hostname set to foster
value = 0 = 0x0
3
Use the
ethAddrSet
command to set the host network address. The IP address is specified as four
decimal numbers, separated by periods.
foster > ethAddrSet "192.168.1.54"
Host Address set to 192.168.1.54 for Ethernet interface
value = 0 = 0x0
If you need to set a netmask, specify it after the network address:
foster > ethAddrSet "10.0.0.2", "255.0.0.0"
If you need a network route and/or default gateway, you must specify it.
foster > gateAddrSet "192.168.1.1"
value = 0 = 0x0
When more complicated routing is required, use the
route
command to specify the destination
address, as a full address (single host) or as an abbreviated subnet address. Specify the address of the
gateway that is reachable on the local subnet.
foster > route "add", "206.0.0", "192.168.1.1"
value = 0 = 0x0
4
Optionally, add User account for Telnet
If you want to access the SNC’s command line interface through its Ethernet port using a Telnet
session, you need to add a user account. The user name you specify must be three or more characters.
The password you specify must be eight or more characters.
foster > userAdd "username","password"
value = 0 = 0x0
5
Enter the
reboot
command to reboot the SNC:
foster > reboot
Updating the SNC
Follow the steps below to update the SNC. For more information on the commands used in this procedure,
see
Commands Listed Alphabetically by Function
on page 63.
1
From the service terminal, enter the
normalBoot
command.
2
Wait until the SNC has finished booting.
3
From the service terminal, enter the
version
command.
4
Write down the operating software version number.
5
Determine whether the SNC’s firmware version requires an update.
If an update is required, download the new file or files and the associated readme.
You will install the new firmware as you complete the
Post-Repair Checklist
on page 32.
6
If you replaced the SNC, enter the
ridTag
command and type the identifier.
Summary of Contents for SNC 4000
