![background image](http://html1.mh-extra.com/html/quantum/snc-4000/snc-4000_user-manual_4004472116.webp)
110
Service Port Command Reference
When you enter this command, the settings are stored in memory but are not applied until you enter the
sfmAccessApply
command. The following example shows how to enable the host at connection index 1
to access LUNs 2 through 32. Existing hostindex values can be determined by looking at the “Id” column in
the output of the
sfmShow -1
command.
SNC4000 > sfmAccessSet 1,2,32,1
value = 0 = 0x0
sfmActiveSet
The
sfmActiveSet
command places SFM in the active state. This means that all of the current access
settings are put into effect. You would typically only use this command after making SFM inactive. See the
sfmInactiveSet
command.
SNC4000 > sfmActiveSet
value = 0 = 0x0
If SFM is already active, the following is displayed.
SNC4000 > sfmActiveSet
SFM: Already Active
value = 21 = 0x15
sfmConnectionSet [hostindex],“host connection string”
The
sfmConnectionSet
command sets the host connection information for the host at the specified
connection index. The connection may be a device name, port address, etc. The following example shows
setting the host connection information. Existing hostindex values can be determined by looking at the “Id”
column in the output of the
sfmShow -1
command.
SNC4000 > sfmConnectionSet 1,"ScsiPort2 [0:0:0] (QLA2100)"
value = 0 = 0x0
sfmFeatureDisable
The
sfmFeatureDisable
command disables the SFM feature. It erases the appropriate configuration file,
and reboots the appliance. No provision is made to restore the existing configuration. Users should save
the appliance configuration before disabling the feature.
For more information, see
Saving a Configuration File
on page 17.
SNC > sfmFeatureDisable
All SFM configuration information will be lost, the feature disabled, and
the system will be atuomatically rebooted! Do you want to disable SFM?
(y or n) y
sfmFeatureEnable “license key string”
The
sfmFeatureEnable
command enables the SFM feature. Each license key is unique for each SNC
4000 serial number. The SFP is factory-enabled, so you can specify “enable” rather than an actual license
key.
Access Value
0
Disables access to the LUNs
1
Enables access to the LUNs
Summary of Contents for SNC 4000
