![background image](http://html1.mh-extra.com/html/quantum/snc-4000/snc-4000_user-manual_4004472048.webp)
42
Maintenance Action Plans
Event Viewing Levels
Numerical equivalents for the event viewing levels from the Viewing Level column of
Table 5
are explained
in
Table 6
.
Start MAP
Gather as much information as possible before performing a repair action. When gathering information, you
may need to connect the service terminal to the service port. See
Connecting to the Service Port
on page
23.
Event Code or Obvious Symptom
Either an event code has been reported by the ADIC Management Console or an error has been observed
by other means. For more information on events, see the
ADIC Management Console User’s Guide
.
If the event code is known, go to
Table 4
on page 37 with that event code and perform the recommended
action. If the symptom is obvious, go to
Table 3
on page 35.
If the event code or error symptom is not known, go to
Event Codes and Actions
on page 35.
Otherwise, proceed to
Visually Inspect LEDs
on page 42.
Visually Inspect LEDs
Use this procedure to visually inspect the LEDs.
1
Observe interface panel SNC LED status indicators.
8
Go to
Service Port MAP
on page 60
9
Contact your network administrator
10
Reduce the number of target devices attached to the SNC
11
Go to
Start MAP
on page 42
12
Go to
Device Access MAP
on page 45
13
Go to
Retrieving the Code 43 Dump File
on page 137.
Table 6
Event Viewing Levels
Number
Level
Explanation
0
Notice
Events recorded in the Event Log but not displayed by
the Event Viewer
1
Warning
Includes events that should always be reported, such
as device removals, and changes to temperature or
power systems
2
Information
Includes events that might result in later problems
Table 5
Action Reference Table
Action
Number
Action
Summary of Contents for SNC 4000
