120
Service Port Command Reference
Device Index 08
IO Class Enum n/a
IO Type Enum n/a
Label Index 03
Bus Id 1.0.0
-------- SCSI 2 VPD --------
IO Class Fixed IO
IO Type SCSI
IO Mfg LSI Logic
Device Index 09
IO Class Enum n/a
IO Type Enum n/a
Label Index 03
Bus Id 1.0.1
sz “filename”
The
sz
command initiates a send Zmodem file transfer session. You use this command when you want to
save configuration information to a file in case the SNC 4000 needs to be replaced. The SNC 4000 uses
Zmodem protocol to upload its persistent address map database and configuration parameter settings from
its nonvolatile flash memory to a file on the service terminal. After issuing this command, you start the file
transfer from the service terminal by initiating a receive file operation that uses Zmodem protocol.
The filename “config.cfg” is shown in the example below. You can specify a different name for the file but
the name must not exceed 8 characters and it must end in .cfg. See also the
rz
command for information
about receiving a configuration file.
SNC4000 > sz "config.cfg"
Configuration Download Complete: config.cfg
value = 0 = 0x0
SNC4000 >
targets
The SNC 4000 maintains a list of target devices that are attached to the I/O channels. The
targets
command will list each device currently attached, providing descriptions of the devices.
SNC4000 > targets
Idx Tdev Vendor Product Rev | Type Specific
----------------------------------------------|---------------
0 0xc194a400 ADIC Local 0252 | Cmd/Cntrl Status 0h
2 0xc1ffc390 ADIC 5324 | Tape: Blk Size 32768 , flags 7h
3 0xc1ffc290 ADIC 5324 | Changer: flags 7h
value = 4 = 0x4
Idx
Device Index in the target list.
Tdev
An internal pointer, used for some diagnostic operations
Vendor
The content of the Vendor ID field from the SCSI Inquiry Data
Product
The content of the Product ID field from the SCSI Inquiry Data
Rev
The content of the Revision ID field from the SCSI Inquiry Data
Type Specific
For each device type, information pertinent to the device
Summary of Contents for SNC 4000
