![background image](http://html1.mh-extra.com/html/quantum/snc-4000/snc-4000_user-manual_4004472029.webp)
SNC 4000 User’s Guide
23
Connecting to the Service Port
The service port on the SNC is an RS-232C port, configured at 19200 Baud, with 8 data bits, 1 stop bit, no
parity and either hardware flow control or Xon/Xoff flow control.
To connect the SNC service port, a service terminal will be required. The service terminal can be any
standard personal computer that contains a serial (COM) port. Connection between the SNC and the
service terminal is established using a 9-pin to 9-pin straight through cable.
Service Port Connections
The figure below shows the service port connections.
Figure 6
Service Port Pinout
Connections are listed in the following table.
Note
Some systems, such as Unix workstations, may require a different cable or
adapter to connect to the SNC service port.
Table 1
DB-9 RS-232 Connector Pin Assignments
Pin
Number
Signal Name
Abbreviation
Direction relative to SNC
4000
1
Carrier Detect
CD
In
2
Transmit Data
TD
Out
3
Receive Data
RD
In
4
Data Terminal Ready
DTR
Out
5
Signal Ground
SG
-
Summary of Contents for SNC 4000
