![background image](http://html1.mh-extra.com/html/quantum/snc-4000/snc-4000_user-manual_4004472111.webp)
SNC 4000 User’s Guide
105
scsiHostIdSet [channel],[id]
The
scsiHostIdSet
command sets the Host ID for a specified SCSI Channel.
SNC4000 > scsiHostIdSet 2,7
Host Id set to 7 for SCSI 2
will take effect upon reboot
value = 0 = 0x0
scsiRescan [channel]
The command
scsiRescan
requests a SCSI rescan for new devices. If channel is specified (1 or 2), then
only that channel is scanned. Otherwise, if channel is not specified or if channel is 0, then all channels are
scanned.
SNC4000 > scsiRescan 2
Done
value = 0 = 0x0
Rescanning a SCSI bus may delay I/O commands pending on that bus for several seconds. Do not rescan
SCSI buses when this delay may not be tolerated. When possible, only scan the bus where a new device
has been added.
When a device is discovered, there may be further device specific initialization that continues after the scan
has completed in which case the device may not show up immediately when you issue the
fcShowDevs
command. An example of this is a disk that requires a SCSI Start Unit command to become ready. (Tape
and Changer devices and Disks that indicate Ready status are available on scan completion).
If a SCSI target device should require replacement, remove the old device, set the new device to the same
SCSI bus ID as the old device and attach it to the same channel. Rescan the channel to update the
configuration data. The new device should be available to host systems with the same LUN as the old
device.
scsiResetDisableGet [channel]
The
scsiResetDisableGet
command displays the SCSI Bus Reset On Power Up is enabled. False
means that SCSI Bus Reset On Power Up is disabled.
SNC4000 > scsiResetDisableGet
SCSIbus Reset Disable ------- ---------------
SCSI 1 TRUE
SCSI 2 FALSE | default
value = -1 = 0xffffffff
scsiResetDisableSet [channel],[mode]
The
scsiResetDisableSet
command sets the SCSI Bus Reset On Power Up for the specified SCSI
channel. False is default and enables reset of SCSI bus on power-up. True disables SCSI bus reset on
power-up.
Parameter
Value
SCSI Channel Number
1 - 2
ID
0 -15
CAUTION
You must reboot the SNC 4000 after executing this command for the
new settings to take effect.
Summary of Contents for SNC 4000
