84
Service Port Command Reference
fcShowDevs
The
fcShowDevs
command displays information about the devices that are accessible from each FC
interface. The display shows the LUN that the SNC 4000 has assigned to each device, the SCSI Channel
that the device is attached to, the actual SCSI ID and LUN of the device, the vendor, product, revision and
serial number of the device.
SNC4000 >fcShowDevs
Targets Visible to Hosts on FC 1:
LUN Chan Id Lun Vendor Product Rev SN
-----------------------------------------------------
0 0 0 0 ADIC Scalar SNC 413* 601526
1 1 6 0 ADIC Scalar 100 100A ADIC_1_07032002002
2 1 1 0 IBM ULT3580-TD1 22U0 6811088354
22 2 2 0 IBM ULT3580-TD1 22U0 6811085725fcShowNames
fcShowNames
The
fcShowNames
command displays the node and port names (addresses) of the FCs.
Ctlr Id
Indicates the Channel Number for the interface
PCI Addr
The PCI address of the interface, showing bus, device id, and function number.
ISPType
The type of FC Controller, ISP2310.
Node Name
The FC node name for the SNC 4000.
Port Name
The FC port name for the interface.
fcTxDisable [port]
The
fcTxDisable
command disables a FC port transmitter.
SNC4000 > fcTxDisable 1
value = 0 = 0x0
fcTxEnable [port]
The
fcTxEnable
command enables or re-enables a FC port transmitter
SNC4000 > fcTxEnable 1
value = 0 = 0x0
CAUTION
If the Firmware State is anything but Ready, the information output by
this command will be unreliable.
Parameter
Value
Meaning
Port
1
The SNC connection labeled FC1
Parameter
Value
Meaning
Port
1
The SNC connection labeled FC1
Summary of Contents for SNC 4000
