62
Maintenance Action Plans
If the output from the
licenseShow
command shows that SFM is not Valid, exit this MAP and contact
your service representative.
8
Use the ADIC Management Console to verify the host and target device access settings. For more
information, see the
ADIC Management Console User’s Guide
.
Exit this MAP.
If the ADIC Management Console is not available, you can temporarily make SFM inactive to verify that
the host can access all devices. Proceed to
Verify Host Access to Devices
on page 62.
Verify Host Access to Devices
1
Shut down all of the hosts.
2
Enter the
sfmInactive Set
command from the service terminal.
For more information, see the
sfmInactiveSet
on page 112.
3
Startup one of the hosts.
4
If the host can access all of the target devices, shut down the host and repeat
Step 2
and
Step 3
for
each of the other hosts.
If each host can access all devices then there is a problem with the Scalar Firewall Manager Access
settings. Go to
Step 5
.
If the host cannot access all of the target devices, then there is a problem with the devices or their SAN
connections. Proceed to
Device Access MAP
on page 45 or
Fibre Channel MAP
on page 52.
5
Shut down all of the hosts.
6
Enter the
sfmActiveSet
command from the service terminal.
For more information, see the
sfmActiveSet
on page 110.
7
Use the ADIC Management Console to verify the host and target device access settings. For more
information, see the
ADIC Management Console User’s Guide
.
Summary of Contents for SNC 4000
