114
Service Port Command Reference
showBox
The
showbox
command displays components of the SNC 4000 using characters to form a picture of the
unit, as viewed from the back of the SNC 4000:
SNC4000 > showBox
Back __________________________
/ /|
/ / |
/ / |
/ / |
/=========================/ |
| FC1 [SFP SW-2] | |
| | /
| SCSI1 [LVDT] | /
| | /
| SCSI2 [LVDT] | /
|_________________________|/ Front
SFP SW-2 == Small Form Factor Plugable Short Wave Two GigaBit Optical
LVDT = SCSI Low Voltage Differential - Terminated
The abbreviations used in the drawing are explained in the legend immediately below the drawing.
showVersions
The
showVersions
command displays the version of the operational firmware, Power-On-Self-Test
(POST), bootrom and Alternate bootrom.
SNC4000 > showVersions
ADIC Scalar Storage Network Controller Firmware-4
Version 0404.05 Built Oct 19 2001, 14:40:29 on 5xame by jsmyder
POST version v040405
Bootrom version v040405
Alt Bootrom version v040405
value = 0 = 0x0
showScsiAssign
The
showScsiAssign
command lists the current assigned addresses for the indicated channel. If channel
is omitted, or is 0 (zero) then all assignments are shown for all Target channels.
SNC4000 > showScsiAssign
SCSI 1
ID Lun DevId
0 0 1
0 1 17
0 2 35
0 3 51
value = 0 = 0x0
sncFeatureEnable "licensekeystring"
The
sncFeatureEnable
command enables the optional Data Mover Module feature.
SNC4000 > sncFeatureEnable "BVRXC-G79DN"
value = 0 = 0x0
CAUTION
If the license key was factory-installed, you can enter the word
“enable” rather than the actual license key.
Summary of Contents for SNC 4000
