QNAP VIOSTOR, User Manual, Page: 353 / 387

353

Auto port detection and configuration:
If devices are connected to other ports, the system will automatically
detect the change and move all settings (excluding advanced settings) to
the new ports. Users do not have to set it up all over again.
1.
Add a supported camera to the port:

If it is a new camera, the NVR will automatically add it using
default settings.

If it is a camera that has been used before, the NVR will use its
previous settings.
2. Removing the camera from the port will clear the camera settings.
3. Any port changes will be saved in the system logs.
If you want to check Qstart mode, please go to [Surveillance Settings] ->[Advanced
Settings]->[ Qstart Settings]. Also be sure to use supported switches to enable Qstart
mode. The brand and model name will be shown and users can test the connection.
Qstart mode is enabled by default if users select Qstart during initialization.
Otherwise it will be disabled. Users can also choose Manual Setup for initialization if
they are not planning to use Qstart. In Qstart mode, you cannot add cameras to
specific channels. To get around this limitation, you must disable Qstart in Advanced
Settings.