Omron XPECTIA FZ3, User Manual

Page: 202 / 440

2
Measurement
200 L FZ3 Processing Items List Manual
Setting item
Set value
[Factory default]
Description
Extraction condition
●
[Not selected]
●
Area
●
Gravity X
●
Gravity Y
●
Elliptic axis angle
●
Elliptic major axis
●
Elliptic minor axis
●
Elliptic ratio
●
Rectangle width
●
Rectangle height
●
Rectangle X1
●
Rectangle Y1
●
Perimeter
●
Circularity
●
Fit rect major axis
●
Fit rect minor axis
●
Inscribed circle R
●
Circum. circle R
●
Number of holes
Set the extraction
conditions.
Extraction condition setting
●
[AND]
●
OR
Set the "Extraction
conditions".
AND: When all the set
"Extraction conditions" are
fulfilled.
OR: When any of the set
"Extraction conditions" is
fulfilled.
4.
When the setting has been changed, tap [Measurement] in the Detail area to verify whether
measurements can be made correctly.
Measurement Parameters (L)
Set the labeling conditions.Specify the labeling processing, number of labels and sorting conditions.
Measurement parameter can be changed as needed to address unstable measurement results or to
increase the processing speed.Normally, the factory default value will be used.
1.
In the Item Tab area, tap [Measurement].
2.
If necessary, in the "Labeling condition" area, specify a value for each item.
When labeling processing is set to be performed, the feature quantities are measured for each
extracted label.When labeling processing is set to not be performed, the feature quantities are
measured treating all the extracted labels as one label.
When labeling processing is set to be performed, the following items are set.
Acesst 1.0 6251194