Omron F3SG-SR Series, User Manual

Page: 227 / 399

199
F3SG-SR
User’s Manual
Chapter
4
Changing Settings with SD Manager 3
Setting with SD Manager 3
E

Designated Beam Output Setup Procedure
1.
Set the output operation mode of the auxiliary output in [Designated beam output information], and
press the [Zone Setting] button.
2.
Enable the designated beam output function (No.1).
3.
Set up the zone (Refer to

Designated Beam Output Zone Setup Procedure below.) (No. 2, 3, and 4).
4.
Set up the designated beam unblocked state (No. 5).
5.
Click the [Write configuration] button. On the settings list which will appear, confirm that the changed
settings are correct, and click the OK button.

Designated Beam Output Zone Setup Procedure
Select a setup method (No. 2)
[Setting by Manual] (No. 3)
Select a zone No., and set up the bottom and top beam numbers.
Click the [Execute] button in [Confirm zone] to determine the designated beam output zone between
the bottom and top beams configured above. (No. 4)
[Setting by Teach-in]
Selecting [Teach-in] switches the state to the Teach-in mode.
Block the F3SG-SR in the zone that you wish to set up as the designated beam output zone.
Click the [Execute] button in [Confirm zone] to determine the designated beam output zone between
the bottom and top beams blocked. (No. 4)
Select [Manual] in [Setting by] after the zone is determined (No. 2).