Olympus OEP-3, Service Manual

Page: 88 / 176

2-8
OEP-3 V1 (UC)
BVTT
3
x
6
BVTT 3
x
6
BVTT 3
x
6
Flexible flat
cable (24-pin)
SY-282
board
Harness
Flexible flat
cable (14-pin)
Mechanical
block
Connector (CN306)
PRT-13 board
Connector
(CN501)
Connector
(CN203)
Connector
(CN206)
Connector
(CN302)
Harness
Connector
(CN301)
SE-539
board
AN-15 board
Connector
(CN101)
SE-539
board
Harness
Flexible flat
cable (30-pin)
Harness
Harness
Connector
(CN105)
Connector
(CN102)
Connector
(CN302)
Connector
(CN604)
Connector
(CN601)
Connector
(CN605)
Connector
(CN101)
Connector
(CN106)
Connector
(CN103)
Harness
Mechanical block
Clamper
BVTT
3
x
6
BVTT
3
x
6
BVTT 3
x
6
Connector
(CN602)
Connector
(CN150)
Connector
(CN610)
Connector
(CN603)
Connector
(CN104)
2-3-8. Replacement of Mechanical Block
1. Remove the top cover. (Refer to Section 2-2-1.)
2. Remove the front panel assembly.
(Refer to Section 2-2-2.)
3. Disconnect the two flexible flat cables from the
connectors (CN306 and CN501) on the PRT-13 board
and one harness from the connector (CN302).
4. Disconnect the harness (CN301) from the connector
on the SE-539 board.
5. Disconnect the harness (CN101) from the connector
on the AN-15 board.
6. Remove the six screws, then remove the mechanical
block.
7. Install the mechanical block in the reverse order of
steps 1 to 6.
2-3-9. Replacement of SE-539 Board
1. Remove the top cover. (Refer to Section 2-2-1.)
2. Remove the front panel assembly.
(Refer to Section 2-2-2.)
3. Remove the mechanical block.
(Refer to Section 2-3-8.)
4. Disconnect the 12 harnesses from the connectors
(CN101 to CN106, CN302, and CN601 to CN605) on
the SE-539 board and the two flexible flat cables from
the connectors (CN150 and CN610).
5. Remove the four screws and one clamper, then remove
the SE-539 board.
6. Install a new SE-539 board in the reverse order of
steps 1 to 5.