Olympus OEP-3, Service Manual

Page: 46 / 176

1-40
OEP-3 V1 (UC)
78
Installation and Adjustment
Supplied Accessories (Contin
ued)
Preparing the Remote Control Unit
The following remote control units allow you to control the printer remotely. •
MAJ-898 Remote Control Unit (supplied): Used to connect to the REMOTE 1 connector
•
RM-91 Remote Control Unit (provided by Sony Corporation) and FS-36 Foot switch (provided by Sony Corporation): Used to connect to the REMOTE 2 connector.
•
FS-30 Foot switch (provided by Sony Corporation): Used to connect to the REMOTE 3 connector.
Using the MAJ-898 remote control unit (supplied)
The MAJ-898 Remote Control Unit can be used either as a wireless or wired type. The buttons on the remote control unit duplicate those on the front panel of the printer. (See
“Main Panel
” on page 8 and
“Sub Panel
” on page 9.)
You can use the remote control unit
’s buttons which have the same names as those
on the printer. Inserting batteries Install the batteries in the remote control unit before using it.
1
Remove the battery compartment cover.
2
Insert two R6 (size AA) 1.5 V batteries. Note the polarity. Be careful to insert the batteries correctly.
3
Replace the cover.
79
Installation and Adjustment
Battery life
The battery live depends on how much you use the remote control unit. On average, batteries last for about 6 months. Install fresh batteries as soon as you notice the unit
’s range becoming shorter.
Notes
When using the batteries: •
Remove the batteries from the remote control unit if you do not intend to use it for an extended period of time. The batteries may leak if you leave them in the remote control unit.
•
Should the batteries leak, clean the battery case thoroughly with a soft cloth and install fresh batteries.
•
Be careful to insert the batteries correctly. Note the polarity, as indicated inside the battery compartment.
•
Replace exhausted batteries with fresh ones. Never mix a fresh battery with a used battery or with a different kind of battery.
To use the MAJ-898 remote control unit as a wireless unit
When using the remote control unit as a wireless unit, aim the head of the remote control unit at the remote sensor on the printer. With fresh batteries, the range of the remote control unit is about 3 meters.
Using the RM-91/FS-30/FS-36 (provided by Sony Corporation)
The operations to be remotely controlled by the RM-91 remote control unit or the FS-30 foot switch depend on the remote operation settings made with the FUNCTION SETUP menu. (
“Selecting the Operation Mode for Automatic
Printing Capabilities
” on page 111.)
FS-36 has three switches that have different functions. For detailed information on how to use those switches, refer to the manual supplied with the FS-36.