Olympus OEP-3, Service Manual

Page: 94 / 176

3-2
OEP-3 V1 (UC)
4. Resetting the number of estimated head print sheets
(1) Set the power switch to ON while pressing the
←
and
→
keys simultaneously. The printer then
enters the service mode.
(2) Message “HIT ANY KEY” is displayed. Press any key.
(3) A menu is displayed.
(4) Move the cursor to “HEAD PRN:”.
(5) Press the CLEAR key while pressing the EXEC key. The number of estimated print sheets is then
reset.
5. Printing other patterns
(1) Set the power switch to ON while pressing the
←
and
→
keys simultaneously. The printer then
enters the service mode.
(2) Message “HIT ANY KEY” is displayed. Press any key.
(3) A menu is displayed.
(4) Move the cursor to “PATTERN” when printing other patterns.
(5) Press the
←
and
→
keys to display the required test pattern name.
(6) Press the EXEC key. A test pattern is then displayed on the monitor.
(7) Press the PRINT key to start printing.
n
At that time, the printer does not control the thermal head temperature. The printer immediately
enters the print operation when you press the PRINT key.
m
.
In the state where an error (e.g., no paper or no ribbon) exists, the printer operates with the error
displayed. In this case, press the MENU key, then press the
←
and
→
keys to display a service
menu. Next, perform each operation described above.
.
This test pattern cannot be output in the state where MULTI PIX is set to “2”. When MULTI PIX is
other than “1”, a white frame may be put into the print result of a test pattern. In this case, set MULTI
PIX to “1”, then print.