Olympus OEP-3, Service Manual

Page: 14 / 176

1-8
OEP-3 V1 (UC)
14
Operation
Operation
Before Printing
This section describes the following operations that must be made prior to starting printing after mounting the paper tray and paper cover on the printer (see “Assembly
” on page 77) and making the necessary connections (see
“Connections
”
on page 80). •
Loading an ink ribbon cartridge (See below.)
•
Loading paper (See page 17.)
•
Selecting the input signal (See page 19.)
Once the above operations have been completed, there should be no need to repeat them during routine printing. Perform them only when absolutely necessary.
Notes
•
You can replace the ink ribbon cartridge or load paper regardless of whether the power is on or off. However, turning off the power will cause the image stored in the memory to be lost.
•
Use the ink ribbon and paper contained in the same package as a pair. Before attempting to load an ink ribbon cartridge or paper, make sure that the combination of the ink ribbon and paper is compatible.
•
Use only ink ribbon and paper designed for use with this printer. Failing to do so is likely to result in malfunctions. (See
“Ink Ribbon and Paper
” on page 129.)
Loading an Ink Ribbon Cartridge
To make printouts, an ink ribbon cartridge (an ink ribbon holder which has been loaded with an ink ribbon) and paper must be loaded. Load an ink ribbon into the supplied ink ribbon holder, then load the ink ribbon cartridge into the printer
’s ribbon compartment.
Notes
•
When you use the printer for the first time, the thermal head may be out of position. Before attempting to use the ink ribbon cartridge, turn on the power so that the thermal head is placed at the correct position.
•
When transporting the printer, remove the ink ribbon cartridge.
•
Do not throw away the supplied ink ribbon holder even if the ink ribbon is used up. The ink ribbon holder is reusable even though the ink ribbon is not reusable.
•
When you use the UPC-510 Color Printing Pack (provided by Sony Corporation), 200 sheets of printouts can be printed for one ink ribbon roll. Even if you finish one pack of paper containing 100 sheets, do not throw away the ink ribbon. You can use the ink ribbon for another pack of papers.
•
Once an ink ribbon has been completely used up, replace it. An ink ribbon is not reusable.
•
Do not rewind the ink ribbon for reuse.
•
Do not touch the ink ribbon or place it in a dusty location. Finger prints or dust on the ink ribbon will result in imperfect printing or malfunction of the head.
•
U
se the ink ribbon and paper supplied only for the initial operation check of
the printer.
15
Operation
1
Open the front panel by pulling the front panel top toward you.
2
Remove the ink ribbon cartridge by pressing the EJECT button. The ink ribbon cartridge pops out. When you use the printer for the first time, this operation is not required.
Note
Never put your hand into the ink ribbon compartment. The thermal head becomes very hot. You may burn yourself if you touch it.
When the ink ribbon cartridge cannot be ejected
Turn the power off, then back on again. Then, after a while, press the EJECT button.
Note
Turning off the power will cause the image stored in the
memory to be lost. In
this case, capture the image again before printing.
3
Detach the spent ink ribbon from the ink ribbon holder.
1
Remove the spool holding the ink ribbon.
2
Remove the other spool.
Continue to the next page
c