Olympus OEP-3, Service Manual

Page: 82 / 176

2-2
OEP-3 V1 (UC)
2-2. Removal and Installation of Cabinet
2-2-1. Top Cover
1. Remove the M3 case screws, then remove the top
cover.
2-2-2. Front Panel Assembly
1. Remove the top cover. (Refer to Section 2-2-1.)
2. Open the front door in the direction indicated by arrow
1
.
3. Press the EJECT button and take out the cartridge in
the direction indicated by arrow
2
.
4. Press the PUSH portion of the paper feed tray and take
out the tray in the direction indicated by arrow
3
.
5. Take out the delivery tray in the direction indicated by
arrow
4
.
Top cover
M3 case screw
M3 case screw
M3 case screw
PRT-13 board
SY-282 board
PSW
3
x
6
Hooks
Hook
BVTT 3
x
6
Front panel assembly
Power switch rod
Flexible flat cable (14-pin)
Flexible printed
wiring board (16-pin)
Flexible flat cable (12-pin)
Connector
(CN204)
Connector
(CN205)
Connector
(CN502)
PUSH
Delivery tray
Paper feed tray
PUSH portion
Front door
Cartridge
EJECT button
2
1
3
4
1
6. Remove the two screws (PSW 3
x
6) and one screw
(BVTT 3
x
6).
7. Disconnect the flexible printed wiring board from the
connector (CN502) on the PRT-13 board.
8. Remove the four hooks, then remove the front panel
assembly.
9. Remove the VPR-63 board. (Refer to Section 2-3-1.)
10. Disconnect the two flexible flat cables from the
connectors (CN204 and CN205) on the SY-282 board.
11. Remove the power switch rod.
12. Install the front panel assembly in the reverse order of
steps 1 to 11.