Olympus OEP-3, Service Manual

Page: 48 / 176

1-42
OEP-3 V1 (UC)
82
Installation and Adjustment
Connections (Continued)
When connecting the video monitor to the RGB SYNC OUTPUT connectors Normally, set SYNC ON G in the OUTPUT SETUP menu to ON. Set SYNC ON G to OFF in the following case: If the images displayed on the video monitor become greenish, compared with the printout, then, adjust the video monitor color (set the adjusted value of the video monitor color to the default). (See
“Matching the Video Monitor Color to the Printer Color
” on page 90.) If the
images on the video monitor are still greenish, set SYNC ON G to OFF.
Making Connections to Enable Remote Control
Enabling remote control using the video system center
The OEP-3 can be controlled remotely by connecting the video system center to the OEP-3. When the EVIS video system center is connected, it remotely controls the OEP-3 so that the printer captures four-reduced images and then makes four- reduced image printouts automatically.
Note
The OEP-3 cannot capture four-reduced images via the video system center for about 30 seconds after completing printing. To capture images continuously, use the operation buttons on the sub panel or the MAJ-898 Remote Control unit (supplied).
Video system center
a)
to PRINTER REMOTE connector
to RS-232C
to AC IN
to wall outlet
Remote cable MD-433 or MH-995
AC power cord (supplied)
a)
When you control the OEP-3 using the video system center, check that the baud rate is set to 4800 bps. (See
“Setting the Baud Rate for Computer Communication
” on page 120.)
83
Installation and Adjustment
B
A
C
Computer
a)
to RS-232C
to REMOTE 1
to REMOTE 2
to REMOTE 3
RM-91 (Provided by Sony Corporation)
b)
MAJ-898 (supplied)
FS-30 (Provided by Sony Corporation)
c)
RS-232C cable
to AC IN to wall outlet
AC power cord (supplied)
Enabling remote control using the remote control units
The printer can be controlled remotely by connecting an MAJ-898 Remote Control Unit (supplied), RM-91 Remote Control Unit (provided by Sony Corporation), an FS-30/FS-36 Foot Switch (provided by Sony Corporation) or a personal computer.
a)
When connecting a personal computer, select the appropriate baud rate from the SYSTEM SETUP menu. (See
“Setting the Baud Rate for Computer Communication
” on page 120.)
b)
You can also connect an FS-36 foot switch (provided by Sony Corporation).
c)
You can also control the printer remotely by sending the signal to pin No.5 of the REMOTE 3 connector.