Olympus OEP-3, Service Manual

Page: 59 / 176

1-53
OEP-3 V1 (UC)
104
Installation and Adjustment
Setting Up the Printer (Continued)
V
0D
O
T
(
S
)
ST
A
R
T
:
H
0D
O
T
(
S
)
ST
A
R
T
:
WINDOW SETUP
COLOR : 200
LAY SETUP H START
: 0 DOT (S)
V START
: 0 DOT (S)
H WIDTH
: 896 DOTS
SAVE
: PRESS [ EXEC ]
CANCEL
: PRESS [ EXEC ] : PRESS [ > ]
Q1 A 1
S
V WIDTH
: 464 DOT (S)
When the black line is at the right or left edge
When the black line is at the top or bottom
Note
When a black line still appears, even after adjusting H START or V START, change the printout size.
5
Select SAVE by pressing the
F
or
f
button, then press the EXEC button.
The adjusted values are stored. The LAYOUT SETUP menu appears.
6
Press the MENU button. The regular screen appears.
To clear the adjusted value Select CANCEL in step 5, then press the EXEC button on the sub panel. The values adjusted in step 4 are cleared and the values are reset to the original ones. To reset the adjusted value to defaults Press the
G
and
g
buttons simultaneously. The adjusted values are reset to the
defaults. To check the adjustment result Capture a new image and print it to check that no black frame appears on the printout, that the image is not partially cut, and that no black line appears.
105
Installation and Adjustment
PRN SPEED
: /
H
IG
H
MOTION CHK
P
/c
/
l
/
P
R
N
/
i
/
o
/
RI
N
T
E
R
S
E
T
U
P
PRINTER SETUP
COLOR : 200
/ COL / LAY / PRN / IN / OUT / PRINT QTY.
: 1 [ 1 ~ 9 ]
INTERVAL
: OFF / ON
GAMMA
: S / NORMAL / H : OFF / ON
LOAD USER
: 1 / 2 / 3 [ EXEC ]
SYSTEM
: PRESS [ > ]
FUNCTION
: PRESS [ > ]
C - BALANCE
: PRESS [ > ]
Q1 A 1
S
Adjusting the Color Balance
This function allows you to match the color balance of the printout to that of the monitor by adjusting the color balance of the printouts. However, this adjustment does not affect the color balance of the monitor. Also, you should use the ink ribbon and paper that are contained in the same package as a pair. The color balance may differ depending on each pair. It is recommended that you adjust the color balance each time you load a new ink ribbon and paper pair so as to compensate the color balance difference. Before adjusting the color balance Reset all items in the COLOR ADJUST menu to the defaults. (See
“Adjusting the
Printout Color
” on page 93.)
1
Display the source image on the video monitor by using the SOURCE/ MEMORY button.
2
Press the MENU button, then select PRN by pressing the
G
or
g
button.
The PRINTER SETUP menu appears on the source image.
SOURCE/ MEMORY
MEMORY
PAGE
CAPTURE
PRINT
PRINT
ALARM
POWER
1
2,11
3,5,7,10
4
5
5,7,10
6
8
Switch PRN to green by pressing the
G
or
g
button.
Display PRN in capital letters by pressing the
G
or
g
button.
Continue to the next page
c