NEC Express5800/53La, User Manual, Page: 266 / 314

D-8 Installing Windows 7
Create from the menu which appears when running NEC Express5800 Workstation
with NEC EXPRESSBUILDER.
If you have only NEC Express5800 Workstation to create Windows 7 OEM-Disk for
EXPRESSBUILDER, use this procedure.
If Windows 7 can be operated on NEC Express5800 Workstation, you can use the other procedure
described later.
Follow the steps below.
1.
Prepare one Flash FDD, or one USB floppy disk drive and 3.5-inch floppy disk.
2.
Turn on your NEC Express5800 Workstation.
3.
Insert the NEC EXPRESSBUILDER DVD into the optical disk drive of the Workstation.
4.
Press the RESET switch or press Ctrl, Alt and Delete to reboot the Workstation. (You may
also turn off and then on again to reboot the Workstation.)
The system will boot from the DVD and NEC EXPRESSBUILDER starts.
5.
Select [Create the OEM-Disk for Windows] from [Tools Menu] step.
6.
Connect the Flash FDD or the USB floppy disk drive.
(If you use the floppy disk drive, insert a floppy disk into it.)
7.
Select [Create a Windows 7 OEM-Disk for EXPRESSBUILDER] at [Create OEMDisk]
and click [Perform].
8.
Windows 7 OEM-Disk for EXPRESSBUILDER will be created.
Write-protect and attach a label, then keep it safely.
IMPORTANT: If you have created "OEM-Disk" into the Flash FDD,
disconnect it after the NEC EXPRESSBUILDER had been
shutdowned.
NOTE:
If the following message is displayed, the floppy disk is write-
protected.
Cancel write-protected state.
If you have already cancelled write-protected state, connect the floppy
disk drive again.