NEC Bull NovaScale R620 Series, User Manual

Page: 266 / 346

NovaScale R620 User Guide
7-4
POST Error Messages
Powering on the server automatically starts the self-diagnostic program, POST (Power On Self-Test). When POST
detects any error, it displays an error message and its measure on the display unit. Follow the table below to
troubleshoot such errors.
Phoenix BIOS 4.0 Release 6.0.XXXX
:
CPU=Pentium III XXX MHz
0640K System RAM Passed
0127M Extended RAM Passed
WARNING:
02B0: Diskette drive A error.
:
press <F1> to resume, <F2> to SETUP
Message indicating a floppy disk drive error
TIPS:
For error messages on optional PCI boards, refer to the manual provided with those options.
On-screen error message Cause Action
0200 Failure Fixed Disk

Hard disk is faulty

CPU/IO module is faulty.

Replace the hard disk.

Replace the CPU/IO module.
0210 Stuck Key Keyboard connection error

Disconnect the keyboard and connect it back
again.

Replace the keyboard.
0211 Keyboard error Keyboard is faulty.

Disconnect the keyboard and connect it back
again.

Replace the keyboard.

If restarting does not help, replace the CPU/IO
module.
0212 Keyboard Controller
Failed
Keyboard controller is faulty. If restarting the server does not help, replace the
CPU/IO module.
0213 Keyboard locked -
Unlock key switch
Keyboard is locked. Unlock the key switch.
0230 System RAM Failed at
offset
DIMM is faulty.

Replace DIMM.

Replace the CPU/IO module.
0231 Shadow RAM Failed at
offset
Shadow RAM is faulty.

Replace DIMM.

Replace the CPU/IO module.
0232 Extended RAM Failed
at address line
Extended RAM is faulty.

Replace DIMM.

Replace CPU/IO module.
0233 Memory type mixing
detected
Memories of different types
are installed. Memories of different types are installed. Replace
DIMM with appropriate one.
0250 System battery is dead
-Replace and run
SETUP
System battery is dead.

Replace system battery.

Replace CPU/IO module.
0251 System CMOS
checksum bad-Default
configuration used
System CMOS configuration
is changed.

Reconfigure the system CMOS by using BIOS
setup.

Clear system CMOS using hardware jumper.
0252 Password checksum
bad -Password cleared
Password is cleared.

Reconfigure by using BIOS setup.

Clear system CMOS using hardware jumper.
0260 System Timer error System Timer is faulty.
0270 Real time clock error RTC is faulty.
0271 Check date and time
setting
Date and time are incorrectly
set.
Reconfigure by using BIOS setup.
02D0 System cache error -
Cache disabled
CPU cache is faulty.
02D1 System Memory
exceeds the CPU's
caching limit
CPU cache is faulty.
If replacing the CPU does not help, replace the
CPU/IO module.