NovaScale R620 User Guide
8150: NVRAM Cleared By Jumper
Press <F1> to resume, <F2> to Setup
-------------------------------------------------------------------------------------------------
7.
By referring to “Removing CPU/IO Module” in chapter 8, remove the CPU/IO module #0 from the server.
8.
Restore the previous CMOS clear jumper switch settings. Remove the jumper pins 1-2 of the CPU/IO module
#0 and install them on the jumper pins 7-8.
9.
By referring to “Installing CPU/IO Module” in chapter 8, install the CPU/IO module #0 on the server.
10.
Reconnect the power cord of the CPU/IO module #0 and press the POWER switch to power on.
11.
After the start-up, press the
F2
key during POST to start BIOS SETUP.
12.
Make settings in SETUP as you desire and then the settings by selecting “Exit”
→
“Exit Saving Changes.”
Switch the power off and disconnect the power cord from the outlet.
13.
Clear CMOS for the CPU/IO module #1 by following the steps 3 to 12.
14.
By referring to “Installing CPU/IO Module” in chapter 8, install both CPU/IO modules on the server.
15.
Connect both power cords.
4-34
Summary of Contents for Bull NovaScale R620 Series
